Lift / Elevator Manufacturing

Elevator Installation : Once the Lift car and other parts are manufactured in the plant, they are transported to the installation site. The rest of the Lift is assembled on the building site. The building design integrates the Lift shaft from the beginning, and the shaft grows as the building is erected. The walls of the shaft are poured concrete, and the shaft straightness and other dimensions are carefully monitored as each floor goes up. Guide rails, switch ramps, service ladders, and similar support equipment are bolted into the shaft after the shaft walls and roof is complete. Then the counterweight is raised to the top of the building and lowered into the shaft along its rails. The elevator car is then inserted it partly into the shaft. The guide wheels connect the car to the guide rails, and the car is carefully aligned inside the shaft. The hoist motor, governor, controller, and other equipment are mounted in the Machine room, which is located directly over the elevator shaft. Nowadays Lift Manufacturers in Kolkata and elsewhere in the country like us have started manufacturing and installing Machine Room Less (MRL) lifts as well. After the elevator and governor cables are strung and attached, the electrical connections completed, and the controller programmed, the final commissioning is done after trial runs. All of the above process needs precision workmanship to ensure a well erect lift which gives the passengers a feel of safety and comfort while riding the lift.